Master Mount has taken the traditional AK safety lever and “tactically” enhanced it for the modern AK user. The AK Master Mount™ version of the AK safety lever is rugged 16 gauge steel (1.5 mm thick), has an improved ergonomic extended side tab, bolt-hold open feature, and is fully compatible with the AK Master Mount™ side rail mounting hardware.
Available in AKM and Yugo versions. Semi-auto or Full-auto configuration. With or without bolt-hold-open (BHO) notch.
Note: Not compatible with underfolder stocks.
No Other Safety Lever Compares
Our AK Master Mount™ safety lever safety levers are stamped from heavy duty 16 gauge (.060" or 1.5 mm) thick steel, thicker than all the other AK safety levers on the commercial market or those made by the factory! The extended side tab is also thick 16 gauge steel. This makes it rugged and robust, and it will not cut your finger like the safety levers with "razor thin" side tabs. The side tab is textured on BOTH sides for better traction, especially if wearing gloves. The tab is also flat to be easy to move the safety lever in the up AND down directions, and it is angled slightly upward from back to front to be more ergonomic. Then finally it is heat treated to Rockwell C hardness of 30 for added toughness.
Solid Steel
The internal paddle part of the AK Master Mount™ enhanced safety lever is milled from solid steel. It is NOT cast like most of the AK safety levers these days. It is heat treated to Rockwell C hardness of 30 for even more toughness.
Yes, we overbuild our products as we are AK purist. We make a semi-automatic and full-auto configuration.
Correct Safety Lever Stop
The lower edge has the correct embossing to prevent the safety lever from over-riding the safety lever stop tab that extends up from the trigger well.
